Dell PowerEdge FX2/FX2s - Manual (Page 171)

Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information When a static route (or a protocol route) overlaps with Management static route,
the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 management routes. This command manages both tables.
show arp
Displays the ARP table.
Syntax show arp [interface interface ] [dynamic] [summary]
Parameters
interface
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the Management interface, enter the keyword
managementethernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
dynamic (OPTIONAL) Enter the keyword dynamic to view dynamic
entries.
summary (OPTIONAL) Enter the keyword summary to view a summary
of ARP entries.
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
The following describes the show arp command shown in the following example.
Row Heading Description
Protocol Displays the protocol type.
Address Displays the IP address of the ARP entry.
Age(min) Displays the age (in minutes) of the ARP entry.
Hardware Address Displays the MAC address associated with the ARP entry.
Interface Displays the first two letters of the interfaces type and the
slot/port associated with the ARP entry.
VLAN Displays the VLAN ID, if any, associated with the ARP entry.
171