Dell PowerEdge FX2/FX2s - Manual (Page 169)

• For the management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is 0 and the port range is 0.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For VLAN, enter the keyword vlan then by a number
from 1 to 4094.
count value (OPTIONAL) Enter the keywords count then the count value.
The ranges from 1 to 65534. The default is Infinity.
Command
Modes
EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
To stop packets from flooding the user terminal when debugging is turned on, use
the count option.
Example
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40
ICMP: echo request rcvd from src 40.40.40.40
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
ICMP: echo request sent to dst 40.40.40.40:
ip route
Assign a static route to the switch.
Syntax ip route destination mask {ip-address | interface [ip-address]}
[distance]
To delete a specific static route, use the no ip route destination mask
{address | interface [ip-address]} command.
To delete all routes matching a certain route, use the no ip route
destination mask command.
Parameters
destination Enter the IP address in dotted decimal format of the
destination device.
mask Enter the mask in the slash prefix format (/x) of the
destination device’s IP address.
ip-address Enter the IP address in dotted decimal format of the
forwarding router.
169