Dell PowerEdge FX2/FX2s - Manual (Page 376)

The starting point for using LLDP is invoking LLDP with the protocol lldp command in either
CONFIGURATION or INTERFACE mode.
The information LLDP distributes is stored by its recipients in a standard management information base
(MIB). You can access the information by a network management system through a management
protocol such as simple network management protocol (SNMP).
For details about implementing LLDP/LLDP-MED, refer to the Link Layer Discovery Protocol chapter of
the Dell Networking OS Configuration Guide.
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
Syntax advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-
size} command.
Parameters
max-frame-
size Enter the keywords max-frame-size to advertise the dot3
maximum frame size.
Defaults none
Command
Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
advertise management-tlv
Advertise management TLVs (Type, Length, Value).
Syntax advertise management-tlv {system-capabilities | system-
description | system-name}
To remove advertised management TLVs, use the no advertise management-
tlv {system-capabilities | system-description | system-name}
command.
Parameters
system-
capabilities Enter the keywords system-capabilities to advertise the
system capabilities TLVs to the LLDP peer.
system-
description Enter the keywords system-description to advertise the
system description TLVs to the LLDP peer.
system-name Enter the keywords system-name to advertise the system
name TLVs to the LLDP peer.
Defaults none
376