Dell PowerEdge FX2/FX2s - Manual (Page 192)

Command
Modes EXEC
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
Because this command calculates based on a Layer 2 hash algorithm, use this
command to display flows for switched Layer 2 packets, not for routed packets
(use the show ip flow command to display routed packets).
The show port-channel-flow command returns the egress port identification
in a given port-channel if a valid flow is entered. A mismatched flow error occurs if
MAC-based hashing is configured for a Layer 2 interface and you are trying to
display a Layer 3 flow.
The output displays three entries:
• Egress port for unfragmented packets.
• In the event of fragmented packets, the egress port of the first fragment.
• In the event of fragmented packets, the egress port of the subsequent
fragments.
NOTE: In the show port-channel–flow command output, the egress port
for an unknown unicast, multicast, or broadcast traffic is not displayed.
show link-bundle-distribution port-channel
Display the traffic-handling and utilization of the member interfaces of the port channel.
Syntax show link-bundle-distribution port-channel
Command
Modes EXEC
EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information The following table describes the output fields of this show command:
Field Description
Link-bundle trigger threshold Threshold value that is the checkpoint,
exceeding which the link bundle is
marked as being overutilized and alarm
is generated
LAG bundle number Number of the LAG bundle
Utilization (In Percent) Traffic usage in percentage of the
packets processed by the port channel
192