Dell PowerEdge FX2/FX2s - Manual (Page 394)

PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
Related
Commands
dcb-map — creates a DCB map to configure PFC and ETS parameters and applies
the PFC and ETS settings on Ethernet ports.
Quality of Service (QoS)
The Dell Networking operating software commands for quality of service (QoS) include traffic
conditioning and congestion control. QoS commands are not universally supported on all Dell
Networking Products.
Per-Port QoS Commands
Per-port QoS (port-based QoS) allows you to define the QoS configuration on a per-physical-port basis.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the traffic this interface receives.
Syntax dot1p-priority priority-value
To delete the IEEE 802.1p configuration on the interface, use the no dot1p-
priority command.
Parameters
priority-value Enter a value from 0 to 7.
dot1p Queue Number
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Defaults none
Command
Modes INTERFACE
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
394