Dell PowerEdge FX2/FX2s - Manual (Page 137)

• For a Port Channel interface, enter the keyword port-
channel followed by a number. Range: 1-128
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example
Dell#clear counters
Clear counters on all interfaces [confirm]
clear mac-address-table dynamic
Clear the MAC address table of all MAC addresses learned dynamically.
Syntax clear mac-address-table dynamic {interface tengigabitethernet
slot/port-id}
Parameters
interface Enter the keyword interface range and one of the
interfaces — slot/port, port-channel or VLAN number. Select
the range of interfaces for bulk configuration. You can enter
up to six comma separated ranges-spaces are not required
between the commas. Comma-separated ranges can
include VLANs, port-channels and physical interfaces.
Slot/Port information must contain a space before and after
the dash. For example, interface range tengigabitethernet 0/1
- 5 is valid; interface range tengigabitethernet 0/1-5 is not
valid.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
default vlan-id
Set the default VLAN ID.
Syntax default vlan-id <vlan-id>
137