Dell PowerEdge FX2/FX2s - Manual (Page 422)

Related
Commands
power-cycle stack-unit —resets the designated stack member.
show diag — displays the data plane or management plane input and output
statistics of the designated component of the designated stack member.
show system —displays the current status of all stack members or a specific
member.
stack-unit iom-mode
Toggle the FN I/O Aggregator operating mode between programmable multiplex, stand-alone, stack, and
VLT modes.
Syntax stack-unit <unit-number> iom-mode [programmable-mux | stack |
standalone | vlt]
Parameters
unit number
<0-5> Enter the number of the member stack unit. The range is
from 0 to 5.
programmable
-mux Enable programmable multiplex mode.
stack Enable stack mode.
standalone Enable stand-alone mode.
vlt Enable virtual link trunking mode.
Defaults standalone
Command
Modes
• CONFIGURATION
Command
History
Version 9.6.
(0.0) Supported on the FN I/O Aggregator.
Usage
Information This command is supported on the FN410S and the FN410T Aggregators.
Example
Dell(conf)#stack-unit 0 iom-mode stack
% You are about to stack your IOA module, please reload the IOA
and then plug in the stacking cable for the changes to take
effect.
Dell(conf)#
Dell#
Related
Commands
reload — Reboots the operating system.
show system — displays the current status of all stack members or a specific
member.
422