Dell PowerEdge FX2/FX2s - Manual (Page 130)

interface (OPTIONAL) Enter the interface type and slot/port
information:For a VLAN interface enter the keyword vlan
followed by a number from 1 to 4094.
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
debug ip igmp
Enable debugging of IGMP packets.
Syntax debug ip igmp [group address | interface]
To disable IGMP debugging, enter the no ip igmp command. To disable all
debugging, enter the undebug all command.
Defaults Disabled
Parameters
group-address (OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
interface (OPTIONAL) Enter the interface type and slot/port
information:
For a VLAN interface enter the keyword vlan followed by a
number from 1 to 4094.
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
ip igmp snooping flood
This command controls the flooding behavior of unregistered multicast data packets.When flooding is
disabled, unregistered multicast data traffic is forwarded to only multicast router ports in a VLAN. If there
is no multicast router port in a VLAN, unregistered multicast data traffic is dropped.
Syntax ip igmp snooping flood
To disable the flooding, use the no ip igmp snooping flood command.
Parameters Enabled
130