Dell PowerEdge FX2/FX2s - Manual (Page 161)

Usage
Information The following describes the show vlan command information given in the
following example
Column Heading Description
(Column 1 — no
heading)
• asterisk symbol (*) = Default VLAN
• G = GVRP VLAN
• P = primary VLAN
• C = community VLAN
• I = isolated VLAN
NUM Displays existing VLAN IDs.
Status Displays the word Inactive for inactive VLANs and the word
Active for active VLANs.
Q Displays G for GVRP tagged, M for member of a VLAN-Stack
VLAN, T for tagged interface, U (for untagged interface), x
(uncapitalized x) for Dot1x untagged, or X (capitalized X) for
Dot1x tagged.
Ports Displays the type, slot, and port information. For the type,
Po = port channel and Te = ten gigabit ethernet.
Example
Dell# show vlan id 40
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port
Mirroring
VLANs, P - Primary, C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V
- VLT tagged
NUM Status Description Q Ports
1 Inactive a
Dell#
Example (Brief)
Dell#show vlan brief
VLAN Name STG MAC Aging IP
Address
---- -------------------------------- ---- ---------
------------------
1 0 0
unassigned
2 0 0
unassigned
20 0 0
unassigned
1002 0 0
unassigned
Dell#
Example (Using
a VLAN Name)
Dellconf)#interface vlan 222
Dell(conf-if-vl-222)#name test
Dell(conf-if-vl-222)#do show vlan name test
Codes: * - Default VLAN, G - GVRP VLANs
Q: U - Untagged, T - Tagged
161