Syslog commands – Dell PowerEdge FX2/FX2s User Manual
Page 438
NOTE: For v1 / v2c trap configuration, if the community-string is not defined
using the snmp-server community command prior to using this command,
the default form of the snmp-server community command automatically is
configured with the community-name the same as specified in the snmp-
server host command.
Configuring Informs
To send an inform, use the following steps:
1.
Configure a remote engine ID.
2.
Configure a remote user.
3.
Configure a group for this user with access rights.
4.
Enable traps.
5.
Configure a host to receive informs.
Related
Commands
— enables SNMP traps.
Syslog Commands
The following commands allow you to configure logging functions on all Dell Networking switches.
clear logging
Clear the messages in the logging buffer.
Syntax
clear logging
Defaults
none
Command
Modes
EXEC Privilege
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Related
Commands
— displays logging settings and system messages in the internal
buffer.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple
logging servers of both IPv4 and/or IPv6 can be configured.
Syntax
logging {ip-address | ipv6-address | hostname} [vrf vrf-name]
To disable logging, use the no logging command.
Parameters
ip-address
Enter the IPv4 address in dotted decimal format.
ipv6-address
Enter the IPv6 address in the x:x:x:x::X format.
438