Back-up destination, Clear vlt statistics – Dell PowerEdge FX2/FX2s User Manual

Page 455

back-up destination

Configure the IPv4 or IPv6 address of the management interface on the remote VLT peer to be used as
the endpoint of the VLT backup link for sending out-of-band hello messages.

Syntax

back-up destination {[ipv4–address] | [ipv6 ipv6–address]
[interval seconds]}

Parameters

ipv4–address

Enter the IPv4 address of the backup destination.

ipv6

Enter the keyword ipv6 then an IPv6 address in the
X:X:X:X::X format.

interval
seconds

Enter the keyword interval to specify the time interval to
send hello messages. The range is from 1 to 5 seconds. The
default is 1 second.

Defaults

1 second

Command
Modes

VLT DOMAIN

Command
History

Version 9.4(0.0)

Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.

clear vlt statistics

Clear the statistics on VLT operations.

Syntax

Parameters

domain

Clear the VLT statistics for the domain.

multicast

Clear the VLT statistics for multicast.

mac

Clear the VLT statistics for the MAC address.

arp

Clear the VLT statistics for ARP.

igmp-snoop

Clear the VLT statistics for IGMP snooping.

ndp

Clear the VLT statistics for NDP.

Command
Modes

EXEC

Command
History

Version 9.4(0.0)

Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.

Example

VLT ARP Statistics

----------------

ARP Tunnel Pkts sent:0

ARP Tunnel Pkts Rcvd:0

455