Dell PowerEdge FX2/FX2s - Manual (Page 157)

0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 5d5h23m
!-------------output truncated ----------------!
Related
Commands
show diag — Displays data plane and management plane input/output statistics.
show interfaces status
Displays a summary of interface information or specify a stack unit and interface to display status
information for that specific interface only.
Syntax show interfaces [interface | stack-unit unit-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
linecard slot-
number (OPTIONAL) Enter the keyword linecard then the slot
number.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example
Dell#show interface status
Port Description Status Speed Duplex Vlan
Te 0/1 Up 10000 Mbit Full 1-4094
Te 0/2 Up 10000 Mbit Full 1-4094
Te 0/3 Up 10000 Mbit Full 1-4094
Te 0/4 Up 10000 Mbit Full 1-4094
Te 0/5 Up 10000 Mbit Full --
Te 0/6 Up 10000 Mbit Full 1-4094
Te 0/7 Up 10000 Mbit Full --
Te 0/8 Up 10000 Mbit Full --
Te 0/9 Up 10000 Mbit Full --
Te 0/10 Up 10000 Mbit Full --
Te 0/11 Up 10000 Mbit Full --
157