Dell PowerEdge FX2/FX2s - Manual (Page 448)

description
Enter a text description of an uplink-state group.
Syntax description text
Parameters
text Text description of the uplink-state group. The maximum
length is 80 alphanumeric characters.
Defaults none
Command
Modes UPLINK-STATE-GROUP
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Example
Dell(conf-uplink-state-group-16)# description test
Dell(conf-uplink-state-group-16)#
Related
Commands uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
enable
Enable uplink state group tracking for a specific UFD group.
Syntax enable
To disable upstream-link tracking without deleting the uplink-state group, use the
no enable command.
Defaults Upstream-link tracking is automatically enabled in an uplink-state group.
Command
Modes UPLINK-STATE-GROUP
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Related
Commands
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
downstream
Assign a port or port-channel to the uplink-state group as a downstream interface.
Syntax downstream interface
To delete an uplink-state group, enter the no downstream interface
command.
448