Dell PowerEdge FX2/FX2s - Manual (Page 199)

protocol lldp (Configuration)
Enable LLDP globally on the switch.
Syntax protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Enabled.
Command
Modes CONFIGURATION (conf-lldp)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
protocol lldp (Interface)
Enter the LLDP protocol in the INTERFACE mode.
Syntax [no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp
command from Interface mode.
Defaults Enabled
Command
Modes INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
This command is available only in PMUX mode.
By default, protocol lldp is enabled, To disable, use the no protocol lldp
command.
When you enter the LLDP protocol in the Interface context, it overrides global
configurations. When you execute the no protocol lldp from INTERFACE
mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
Syntax show lldp neighbors [interface] [detail]
199