Logging source-interface, Show logging – Dell PowerEdge FX2/FX2s User Manual
Page 241
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog
server.
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging
source-interface command.
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For a TenGigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For VLAN interface, enter the keyword vlan followed by
a number from 1 to 4094.
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator.
Usage
Information
Syslog messages contain the IP address of the interface used to egress the router.
By configuring the logging source-interface command, the Syslog packets
contain the IP address of the interface configured.
Related
Commands
— enables logging to the Syslog server.
show logging
Displays the logging settings and system messages logged to the internal buffer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse
[number] | summary | | driverlog[stack-unit number] | kernellog
[stack-unit number]]
Parameters
number
(OPTIONAL) Enter the number of messages displayed in the
output. The range is from 1 to 65535.
history
(OPTIONAL) Enter the keyword history to view only
information in the Syslog history table.
reverse
(OPTIONAL) Enter the keyword reverse to view the Syslog
messages in FIFO (first in, first out) order.
241