Dell PowerEdge FX2/FX2s - Manual (Page 381)

The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name
command in Interface configuration mode.
Related
Commands
show qos dcb-map – displays the dcb-map profiles configured on the system.
dcb-map stack-unit all stack-ports all – applies a DCB map on all ports of a switch
stack.
description (for FCoE maps)
In an FCoE map, add a text description of the FCoE and FC parameters used to transmit storage traffic
over an FN 2210S Aggregator NPIV proxy gateway in a converged fabric.
Syntax description text
Parameters
text Enter a maximum of 32 characters.
Defaults None
Command
Modes FCOE MAP
Command
History
Version 9.6(0.0) Supported on the FN 2210S Aggregator.
Usage
Information
The text description is displayed in show fcoe-map command output.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map — displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
feature fc
Enables the Fibre channel communication via the NPG functionality.
Syntax feature fc
Command
Modes CONFIGURATION
Default Enabled
Command
History
Version 9.6(0.0) Supported on the FN I/O aggregator.
Usage
Information The command is supported only in FN2210S Aggregator.
381