Dell PowerEdge FX2/FX2s - Manual (Page 350)

• The interface range prompt includes interface types with slot/port
information for valid interfaces. The prompt allows for a maximum of 32
characters. If the bulk configuration exceeds 32 characters, it is represented by
an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port
range is excluded from the prompt.
• If overlapping port ranges are specified, the port range is extended to the
smallest start port and the biggest end port.
Example (Bulk)
Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/4 ,
tengig 0/7
, fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example
(Multiple Ports)
Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/3 - 5
Dell(conf-if-range-te-0/1-5)#
Example
(Overlapping
Ports)
Dell(conf)#interface range tengig 0/1 - 2 , tengig 0/1 - 5
Dell(conf-if-range-te-0/1-5)#
Usage
Information
Only VLAN and port-channel interfaces created using the interface vlan and
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show
running-config command cannot be used with the bulk configuration feature of
the interface range command. You cannot create virtual interfaces (VLAN,
Port-channel) using the interface range command.
NOTE: If a range has VLAN, physical, port-channel, and SONET interfaces, only
commands related to physical interfaces can be bulk configured. To configure
commands specific to VLAN or port-channel, only those respective interfaces
should be configured in a particular range.
Example (Single
Range)
This example shows a single range bulk configuration.
Dell(conf)# interface range tengigabitethernet 0/1 - 5
Dell(conf-if-range-te-0/1-5)# no shutdown
Dell(conf-if-range-te-0/1-5)#
Example
(Multiple
Range)
This example shows how to use commas to add VLAN, and port-channel interfaces
to the range.
Dell(conf-if)# interface range tengigabitethernet 0/1 - 5,
vlan 2 - 10, port-channel 1 - 25
Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)# no shutdown
Dell(conf-if-range-te-0/1-5,vl-2-10,po-1-25)#
Related
Commands
interface port-channel — configures a port channel group.
350