Dell PowerEdge FX2/FX2s - Manual (Page 452)

Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Example
Dell#show uplink-state-group detail
(Up): Interface up (Dwn): Interface down (Dis): Interface
disabled
Uplink State Group : 1 Status: Enabled, Up
Defer Timer : 10 sec
Upstream Interfaces : Po 128(Up)
Downstream Interfaces : Te 0/1(Dwn) Te 0/2(Dwn) Te 0/3(Up) Te
0/4(Dwn) Te 0/5(Up)
Te 0/6(Dwn) Te 0/7(Up) Te 0/8(Up)
Dell#
Related
Commands
• show running-config uplink-state-group — displays the current configuration
of one or more uplink-state groups.
• uplink-state-group — create an uplink-state group and enables the tracking of
upstream links.
uplink-state-group
Create an uplink-state group and enable the tracking of upstream links on a switch/ router.
Syntax uplink-state-group group-id
To delete an uplink-state group, enter the no uplink-state-group group-id
command.
Parameters
group-id Enter the ID number of an uplink-state group. The range is
from 1 to 16.
Defaults none
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
After you enter the command, to assign upstream and downstream interfaces to
the group, enter Uplink-State-Group Configuration mode.
An uplink-state group is considered to be operationally up if at least one upstream
interface in the group is in the Link-Up state.
452