Dell PowerEdge FX2/FX2s - Manual (Page 45)

Lines Beginning
With Description
Control
Processor:... Control processor information and amount of memory on
processor
256M bytes... Amount of boot flash memory on the system
1 34 Port Hardware configuration of the system, including the
number and type of physical interfaces available
upgrade boot
Upgrade the bootflash image or bootselector image.
Syntax upgrade boot {all | bootflash-image | bootselector-image}
stack-unit {0-5 | all} {booted | flash: |ftp: | tftp: |
usbflash:} (A: | B:}
Parameters
all Enter the keyword all to change both the bootflash and
bootselecter images.
bootflash-
image Enter the keywords bootflash-image to change the
bootflash image.
bootselector-
image Enter the keywords bootselector-image to change the
bootselector image.
0–5 Enter the keyword 0–5 to upgrade only the mentioned
stack-unit.
all Enter the keyword all to upgrade all the member stack-
units.
booted Enter the keyword booted to upgrade from the current
image in the I/O Aggregator.
ftp: After entering the keyword ftp:, you can either follow it
with the location of the source file in this form: //
userid:password@hostip/filepath or press Enter to
launch a prompt sequence.
tftp: After entering the keyword tftp:, you can either follow it
with the location of the source file in this form: //
hostlocation/filepath or press Enter to launch a
prompt sequence.
flash: After entering the keyword flash:, you can either follow it
with the location of the source file in this form: //filepath
or press Enter to launch a prompt sequence.
usbflash: After entering the keyword usbflash:, you can either
follow it with the location of the source file in this form: //
filepath or press Enter to launch a prompt sequence.
45