Dell PowerEdge FX2/FX2s - Manual (Page 387)

Command
History
Version 9.6(0.0) Supported on the FN2210S Aggregator.
Version 9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage
Information
Use the show fcoe-map command to display the FC and FCoE parameters used
to configure server-facing Ethernet (FCoE) and fabric-facing FC ports in all FCoE
maps on an FN 2210S Aggregator with the FC Flex IO module NPIV proxy gateway.
In each FCoE map, the values for the fabric ID and FC-MAP that identify the SAN
fabric to which FC storage traffic is sent, and the FCoE VLAN to be used must be
unique.
The following table describes the show fcoe-map brief output shown in the
example below.
Field Description
Fabric-Name Name of a SAN fabric.
Fabric ID The ID number of the SAN fabric to which FC traffic is
forwarded.
VLAN ID The dedicated FCoE VLAN used to transport FCoE storage
traffic between servers and a fabric over the NPIV proxy
gateway. The configured VLAN ID must be the same as the
fabric ID.
FC-MAP FCoE MAC address-prefix value - The unique 24-bit MAC
address prefix that identifies a fabric.
FCF Priority The priority used by a server to select an upstream FCoE
forwarder.
Config-State Indicates whether the configured FCoE and FC parameters
in the FCoE map are valid: Active (all mandatory FCoE and
FC parameters are correctly configured) or Incomplete
(either the FC-MAP value, fabric ID, or VLAN ID are not
correctly configured).
Oper-State Operational status of link to the fabric: Up (link is up and
transmitting FC traffic), Down (link is down and not
transmitting FC traffic), Link-wait (link is up and waiting for
FLOGI to complete on peer FC port), or Removed (port has
been shut down).
The following table describes the show fcoe-map map-name output shown in
the example below.
Field Description
Fabric-Name Name of a SAN fabric.
387