Dell PowerEdge FX2/FX2s - Manual (Page 307)

Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information Specify a stack-unit number on the Master switch in a stack.
Example
Dell(conf)#do show dcb
stack-unit 0 port-set 0
DCB Status :Enabled
PFC Queue Count :2
Total Buffer[lossy + lossless] (in KB):7982
PFC Total Buffer (in KB) :5872
PFC Shared Buffer (in KB) :832
PFC Available Buffer (in KB) :4860
Dell (conf)#
show interface dcbx detail
Displays the DCBX configuration on an interface.
Syntax show interface port-type slot/port dcbx detail
Parameters
port-type Enter the port type.
slot/port Enter the slot/port number.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
To clear DCBX frame counters, use the clear dcbx counters interface
stack-unit/port command.
The following describes the show interface dcbx detail command shown in
the following example.
Field Description
Interface Interface type with chassis slot and port number.
Port-Role Configured the DCBX port role: auto-upstream, auto-
downstream, config-source, or manual.
DCBX Operational
Status Operational status (enabled or disabled) used to elect a
configuration source and internally propagate a DCB
configuration. The DCBX operational status is the
combination of PFC and ETS operational status.
307