Management route – Dell PowerEdge FX2/FX2s User Manual
Page 170
interface
For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
distance
(OPTIONAL) Enter a number as the distance metric assigned
to the route. The range is from 1 to 255.
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator.
Usage
Information
Using the following example of a static route: ip route 33.33.33.0 /24
tengigabitethernet 0/0 172.31.5.43
• The software installs a next hop that is not on the directly connected subnet but
which recursively resolves to a next hop on the interface’s configured subnet. In
the example, if gig 0/0 has an ip address on subnet 2.2.2.0 and if 172.31.5.43
recursively resolves to 2.2.2.0, Dell Networking OS installs the static route.
• When the interface goes down, Dell Networking OS withdraws the route.
• When the interface comes up, Dell Networking OS re-installs the route.
• When recursive resolution is “broken,” Dell Networking OS withdraws the route.
• When recursive resolution is satisfied, Dell Networking OS re-installs the route.
Related
Commands
— views the switch routing table.
management route
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address | ipv6–address}/mask{forwarding-
router-address | managementethernet}
Parameters
{ipv4-address |
ipv6–address}/
mask
Enter an IPv4 address (A.B.C.D) or the IPv6 address followed
by the prefix-length for the IP address of the management
interface.
forwarding-
router-address
Enter an IPv4 address of a forwarding router.
managementet
hernet
Enter the keyword managementethernet for the
Management interface.
Defaults
Not configured.
Command
Modes
CONFIGURATION
170