Dell PowerEdge FX2/FX2s - Manual (Page 433)

-v {1 | 2} (OPTIONAL) Enter the keyword -v then the SSH version 1 or
2. The default is the version from the protocol negotiation.
Defaults As shown in the Parameters section.
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example
Dell#ssh 123.12.1.123 -l ashwani -p 5005 -v 2
username
Establish an authentication system based on user names.
Syntax username name [nopassword | {password | secret} [encryption-
type] password] [privilege level]
If you do not want a specific user to enter a password, use the nopassword
option.
To delete authentication for a user, use the no username name command.
Parameters
name Enter a text string for the name of the user up to 63
characters.
nopassword Enter the keyword nopassword to specify that the user
should not enter a password.
password Enter the keyword password followed by the encryption-
type or the password.
secret Enter the keyword secret followed by the encryption-
type or the password.
encryption-
type Enter an encryption type for the password that you enter.
• 0 directs Dell Networking OS to store the password as
clear text. It is the default encryption type when using the
password option.
• 7 to indicate that a password encrypted using a DES
hashing algorithm follows. This encryption type is
available with the password option only.
• 5 to indicate that a password encrypted using an MD5
hashing algorithm follow. This encryption type is available
with the secret option only, and is the default
encryption type for this option.
password Enter a string up to 32 characters long.
privilege level Enter the keyword privilege then a number from zero (0)
to 15.
433