Dell PowerEdge FX2/FX2s - Manual (Page 366)

Defaults Not configured.
Command
Modes INTERFACE VLAN — (conf-if-vl-n)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information This command enables the IGMP switch to send General Queries periodically. This
behavior is useful when there is no multicast router present in the VLAN because
the multicast traffic is not routed. Assign an IP address to the VLAN interface for the
switch to act as a querier for this VLAN.
IPv4 Routing
The aggregator supports IPv4 routing using the following commands.
ip route
Assign a static route to the switch.
Syntax ip route destination mask {ip-address | interface [ip-address]}
[distance]
To delete a specific static route, use the no ip route destination mask
{address | interface [ip-address]} command.
To delete all routes matching a certain route, use the no ip route
destination mask command.
Parameters
destination Enter the IP address in dotted decimal format of the
destination device.
mask Enter the mask in the slash prefix format (/x) of the
destination device’s IP address.
ip-address Enter the IP address in dotted decimal format of the
forwarding router.
interface For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
distance (OPTIONAL) Enter a number as the distance metric assigned
to the route. The range is from 1 to 255.
Defaults Not configured.
Command
Modes CONFIGURATION
366