Dell PowerEdge FX2/FX2s - Manual (Page 345)

Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
Important Points to Remember:
• Spaces between characters are not preserved after entering this command
unless you enclose the entire description in quotation marks (“desc_text”).
• Entering a text string after the description command overwrites any previous
text string that you previously configured as the description.
• The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port-channel.
• Use the show interfaces description command to display descriptions
configured for each interface.
feature fc
Enables the Fibre channel communication via the NPG functionality.
Syntax feature fc
Command
Modes CONFIGURATION
Default Enabled
Command
History
Version 9.6(0.0) Supported on the FN I/O aggregator.
Usage
Information The command is supported only in FN2210S Aggregator.
flowcontrol
Control how the system responds to and generates 802.3x pause frames on 10G and 40Gig stack units.
Syntax flowcontrol rx {off | on} tx {off | on} threshold
Parameters
rx on Enter the keywords rx on to process the received flow
control frames on this port. This is the default value for the
receive side.
rx off Enter the keywords rx off to ignore the received flow
control frames on this port.
tx on Enter the keywords tx on to send control frames from this
port to the connected device when a higher rate of traffic is
received. This is the default value on the send side.
tx off Enter the keywords tx off so that flow control frames are
not sent from this port to the connected device when a
higher rate of traffic is received.
345