Dell PowerEdge FX2/FX2s - Manual (Page 271)

clear hardware stack-unit
Clear statistics from selected hardware components.
Syntax clear hardware stack-unit 0–5 {counters | unit 0–1 counters |
cpu data-plane statistics | stack-port 9–12}
Parameters
stack-unit 0–5 Enter the keywords stack-unit then 0 to 5 to select a
particular stack member and then enter one of the following
command options to clear a specific collection of data.
counters Enter the keyword counters to clear the counters on the
selected stack member.
unit 0–0
counters Enter the keyword unit along with a port-pipe number,
from 0 to 1 , then the keyword counters to clear the
counters on the selected port-pipe.
cpu data-plane
statistics Enter the keywords cpu data-plane statistics to clear
the data plane statistics.
stack-port 9–
12 Enter the keywords stack-port then the port number of
the stacking port to clear the statistics of the particular
stacking port. The range is from 9 to 12.
NOTE: You can identify stack port numbers by physical
inspection of the rear modules. The numbering is the
same as for the 10G ports. You can also inspect the
output of the show system stack-ports command.
Defaults none
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Related
Commands show diag — displays the data plane or management plane input and output
statistics of the designated component of the designated stack member.
diag stack-unit
Run offline diagnostics on a stack unit.
Syntax diag stack-unit number {alllevels | level0 | level1 | level2
[verbose no-reboot]| terminate| interactive test }
Parameters
number Enter the stack-unit number. The range is from 0 to 5.
alllevels Enter the keyword alllevels to run the complete set of
offline diagnostic tests.
271