Dell PowerEdge FX2/FX2s - Manual (Page 373)

Line Beginning
With Description
Dynamic
Address... Lists the number of dynamically learned MAC addresses.
Static Address... Lists the number of user-defined MAC addresses.
Total MAC... Lists the total number of MAC addresses the switch uses.
Example
(Count)
Dell#show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count : 5
Static Address (User-defined) Count : 0
Total MAC Addresses in Use: 5
Dell#
Link Aggregation Control Protocol (LACP)
This chapter contains commands for Dell Networks’s implementation of the link aggregation control
protocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as port-channels in the
Dell Networking Operating System (OS).
NOTE: For static LAG commands, refer to the Interfaces chapter), based on the standards specified
in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access method
and physical layer specifications.
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
Syntax lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-
timeout command.
Defaults 1 second
Command
Modes INTERFACE (conf-if-po-number)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information This command applies to dynamic port-channel interfaces only. When applied on a
static port-channel, this command has no effect.
373