Tacacs+ commands – Dell PowerEdge FX2/FX2s User Manual
Page 426
TACACS+ Commands
Dell Networking OS supports TACACS+ as an alternate method for login authentication.
tacacs-server host
Specify a TACACS+ host.
Syntax
tacacs-server host {hostname | ipv4-address | ipv6-address}
[port number] [timeout seconds] [key key]
Parameters
hostname
Enter the name of the TACACS+ server host.
ipv4-address |
ipv6-address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)
of the TACACS+ server host.
port number
(OPTIONAL) Enter the keyword port then a number as the
port to be used by the TACACS+ server. The range is from
zero (0) to 65535. The default is 49.
timeout
seconds
(OPTIONAL) Enter the keyword timeout then the number of
seconds the switch waits for a reply from the TACACS+
server. The range is from 0 to 1000. The default is 10
seconds.
key key
(OPTIONAL) Enter the keyword key then a string up to 42
characters long as the authentication key. This
authentication key must match the key specified in the
tacacs-server key for the TACACS+ daemon.
Defaults
Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator.
Usage
Information
To list multiple TACACS+ servers to be used by the aaa authentication login
command, configure this command multiple times.
If you are not configuring the switch as a TACACS+ server, you do not need to
configure the port, timeout and key optional parameters. If you do not
configure a key, the key assigned in the tacacs-server key command is used.
Related
Commands
— specifies the login authentication method.
— configures a TACACS+ key for the TACACS server.
426