Interface managementethernet – Dell PowerEdge FX2/FX2s User Manual

Page 348

• For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

Defaults

Not configured.

Command
Modes

CONFIGURATION

Command
History

Version 9.4(0.0)

Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.

Usage
Information

You cannot delete a physical interface.

By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To
place an interface in mode, ensure that the interface’s configuration does not
contain an IP address and enter the Port Channel Commands command.

The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.

Example

Dell(conf)#interface tengig 0/1

Dell(conf-if-te-0/1)#exit#

Related
Commands

interface port-channel

— configures a port channel.

interface vlan

— configures a VLAN.

interface ManagementEthernet

Configure the Management port on the system.

Syntax

interface ManagementEthernet slot/port

Parameters

slot/port

Enter the keyword ManagementEthernet, then the slot
number (0) and port number zero (0).