Dell PowerEdge FX2/FX2s - Manual (Page 88)

enable
Change the access privilege level.
Syntax enable [user| admin]
Command
Modes
• uBoot
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
help
Displays the help menu.
Syntax help
Command
Modes
• uBoot
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example
BOOT_USER # help
***** Dell Force10 Boot Interface Help Information *****
Current access level: USER LEVEL
Use "syntax help" for more information on syntax.
Available command list (22 commands total):
boot change [primary|secondary|default]
change operating system boot parameters
boot selection [a|b]
change the rom bootstrap bootflash partition
boot show net config retries
show number of retries for network boot config failure
boot write net config retries
write number of retries for network boot config failure
boot zero [primary|secondary|default]
zero operating system boot parameters
default-gateway
default-gateway - set the default gateway ip address
enable [user|admin]
change access privilege level
help
display help menu
-(36%)-Use to continue, q to stop:
BOOT_USER #
88