Dell PowerEdge FX2/FX2s - Manual (Page 151)

Output 4627 packets, 814226 bytes, 0 multicast
Output 0 errors, 0 invalid protocol
Related
Commands
show interfaces configured — Displays any interface with a non-default
configuration.
show interfaces port-channel — Displays information on all interfaces on a specific
stack unit.
show interfaces switchport — Displays Layer 2 information about the interfaces.
show inventory — Displays the I/O Aggregator type, components (including media),
Dell Networking OS version including hardware identification numbers and
configured protocols.
show ip interface — Displays Layer 3 information about the interfaces.
show memory — Displays the stack unit(s) status.
show interfaces status — Displays all interfaces configured using the interface
range command.
show interfaces configured
Displays any interface with a non-default configuration.
Syntax show interfaces configured
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Example
(ManagementE
thernet)
Dell#show interfaces configured
TenGigabitEthernet 0/1 is up, line protocol is down(error-
disabled[UFD])
Hardware is DellForce10Eth, address is 00:01:e8:00:ab:01
Current address is 00:01:e8:00:ab:01
Server Port AdminState is Down
Pluggable media not present
Interface index is 67703553
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :tenG2580001e800ab01
MTU 12000 bytes, IP MTU 11982 bytes
LineSpeed auto
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 05:15:07
Queueing strategy: fifo
Input Statistics:
151