Dell PowerEdge FX2/FX2s - Manual (Page 158)

Te 0/12 Up 10000 Mbit Full --
Dell#
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode
interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax show interfaces switchport [interface | stack-unit unit-id ]
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• Enter the keyword backup to view the backup interface
for this interface.
stack-unit unit-
id (OPTIONAL) Enter the keywords stack-unit followed by
the stack member number. The range is from 0 to 5.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information The following describes the show interfaces switchport command for the
following example.
Items Description
Name Displays the interface’s type, slot, and port number.
802.1QTagged Displays whether if the VLAN tagged (“True”), untagged
(“False”), or hybrid (“Hybrid”), which supports both untagged
and tagged VLANs by port 13/0.
Vlan membership Lists the VLANs to which the interface is a member. Starting
with Dell Networking OS version 7.6.1, this field can display
native VLAN membership by port 13/0.
Example
Dell#show interfaces switchport
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged,
V - VLT
tagged
Name: TenGigabitEthernet 0/1
158