Policy-map-output, Creates an output policy map – Dell PowerEdge FX2/FX2s User Manual

Page 399

Parameters

qos-policy-
name

Enter the name of the policy map in character format (32
characters maximum).

Defaults

none

Command
Modes

CONFIGURATION (policy-map-input and policy-map-output)

Command
History

Version 9.4(0.0)

Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.

Usage
Information

Aggregate input/output QoS policy applies to all the port ingoing/outgoing traffic.
Aggregate input/output QoS policy can coexist with per queue input/output QoS
policies.

If only aggregate input QoS policy exists, input traffic conditioning

configurations (rate-police) apply. Any marking configurations in aggregate

input QoS policy are ignored.

If aggregate input QoS policy and per class input QoS policy coexist,

aggregate input QoS policy preempts per class input QoS policy on input

traffic conditioning (rate-police). In other words, if rate police configuration

exists in the aggregate QoS policy, the rate police configurations in per class

QoS are ignored. Marking configurations in per class input QoS policy still

apply to each queue.

Related
Commands

policy-map-output

— creates an output policy map.

policy-map-output

Create an output policy map.

Syntax

policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.

Parameters

policy-map-
name

Enter the name for the policy map in character format (32
characters maximum).