Snmp commands, Syslog commands – Dell PowerEdge FX2/FX2s User Manual
Page 237
22
Simple Network Management Protocol
(SNMP) and Syslog
This chapter contains commands to configure and monitor the simple network management protocol
(SNMP) v1/v2 and Syslog.
The chapter contains the following sections:
•
•
SNMP Commands
The simple network management protocol (SNMP) is used to communicate management information
between the network management stations and the agents in the network elements. Dell Networking OS
supports SNMP versions 1, and 2c supporting only read-only mode.
Important Points to Remember
• Typically, 5-second timeout and 3-second retry values on an SNMP server are sufficient for both local
area network (LAN) and wide area network (WAN) applications. If you experience a timeout with these
values, the recommended best practice on Dell Networking switches (to accommodate their high
port density) is to increase the timeout and retry values on your SNMP server to the following:
– SNMP Timeout — greater than 3 seconds.
– SNMP Retry count — greater than 2 seconds.
• SNMP operations are not supported on a virtual local area network (VLAN).
Syslog Commands
The following commands allow you to configure logging functions on all Dell Networking switches.
•
•
•
•
•
•
237