Dell PowerEdge FX2/FX2s - Manual (Page 337)

userid:password@hostip/filepath, or press Enter to
launch a prompt sequence.
scp After entering the keyword scp you can either follow it with
the location of the source file in this form://
userid:password@hostip/filepath, or press Enter to
launch a prompt sequence.
tftp After entering the keyword tftp you can either follow it with
the location of the source file in this form://
hostlocation/filepath, or press Enter to launch a
prompt sequence.
flash After entering the keyword flash you can either follow it
with the location of the source file in this form://filepath,
or press Enter to launch a prompt sequence.
usbflash After entering the keyword usbflash you can either follow
it with the location of the source file in this form://
filepath, or press Enter to launch a prompt sequence.
A: Enter this keyword to upgrade the bootflash partition A.
B: Enter this keyword to upgrade the bootflash partition B.
Defaults none
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information You must reload Dell Networking OS after executing this command. Use the
command upgrade system stack-unit to copy Dell Networking OS from the
management unit to one or more stack members.
Example
Dell#upgrade system ?
flash: Copy from flash file system (flash://filepath)
ftp: Copy from remote file system, IPv4 or IPv6,
(ftp:/
/userid:password@hostip/filepath)
scp: Copy from remote file system, IPv4 or IPv6,
(scp:/
/userid:password@hostip/filepath)
stack-unit Sync image to the stack-unit
tftp: Copy from remote file system, IPv4 or IPv6,
(tftp:/
/hostip/filepath)
usbflash: Copy from usbflash file system (usbflash://
filepath)
Dell#
337