Dell PowerEdge FX2/FX2s - Manual (Page 354)

stack-unit port-group port mode ethernet
Converts the interfaces 9 and 10 from Fibre Channel mode to Ethernet.
Syntax stack-unit unit number port-group 0 portmode ethernet
To convert the interfaces 9 and 10 from Ethernet to Fibre Channel mode, use the
no stack-unit unit number port-group 0 portmode ethernet.
Parameters
stack-unit Enter the keyword stack-unit followed by a stack member
number to select the stack unit. The range is 0 to 5.
port-group Enter the keyword port-group followed by 0.
portmode
ethernet Enter the keyword portmode ethernet to convert the
interfaces from Fibre Channel mode to Ethernet.
Command
Modes CONFIGURATION
Command
History
Version 9.6(0.0) Supported on the FN I/O Aggregator.
Usage
Information The command is supported only in FN2210S Aggregator.
negotiation auto
Enable auto-negotiation on an interface.
Syntax negotiation auto
To disable auto-negotiation, use the no negotiation auto command.
Defaults Enabled.
Command
Modes INTERFACE
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
The no negotiation auto command is only available if you first manually set
the speed of a port to 10Mbits or 100Mbits.
The negotiation auto command provides a mode option for configuring an
individual port to forced-master/forced slave after you enable auto-negotiation.
If you do not use the mode option, the default setting is slave. If you do not
configure forced-master or forced-slave on a port, the port negotiates to either a
master or a slave state. Port status is one of the following:
354