Dell PowerEdge FX2/FX2s - Manual (Page 118)

9
FIP Snooping
In a converged Ethernet network, an Aggregator can operate as an intermediate Ethernet bridge to snoop
on Fibre Channel over Ethernet Initialization Protocol (FIP) packets during the login process on Fibre
Channel over Ethernet (FCoE) forwarders (FCFs). Acting as a transit FIP snooping bridge, the switch uses
dynamically-created ACLs to permit only authorized FCoE traffic to be transmitted between an FCoE
end-device and an FCF.
This chapter describes the FIP snooping commands.
clear fip-snooping statistics
Clear the statistics on the FIP packets snooped on all VLANs, a specified VLAN, or a specified port
interface.
Syntax clear fip-snooping statistics [interface vlanVlan-id|
interfaceport-type port/slot|interface port-channel port-
channel-number]
Parameters
vlan-id Enter the VLAN ID of the FIP packet statistics to be cleared.
port type port/
slot Enter the port-type and slot number of the FIP packet
statistics to be cleared.
port-channel-
number Enter the port channel number of the FIP packet statistics to
be cleared.
Command
Modes EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
debug fip-snooping
Enable the debug FIP protocol specific messages.
Syntax debug fip-snooping [all | acl | error | ifm | info | ipc | rx
{ packet-type { all | discovery | virtual-link-instantiation |
118