Dell PowerEdge FX2/FX2s User Manual
Page 419
•
•
show system stack-unit stack-group
•
power-cycle stack-unit
To hard reset any stack unit including master unit.
Syntax
power-cycle stack-unit unit-number
Parameter
Unit number
The unit number ranges from 0 to 5.
Defaults
None
Command
Modes
EXEC Privilege
Command
History
Version 9.6.
(0.0)
Supported on the FN I/O Aggregator.
Usage
Information
This command is supported on the FN410S and the FN410T Aggregators.
This command is used to reset the stack-unit. The master unit can also be power
cycled using this command.
reset stack-unit
Reset any designated stack member except the management unit (master unit).
Syntax
reset stack-unit 0–5 hard
Parameters
0–5
Enter the stack member unit identifier of the stack member
to reset.
hard
Reset the stack unit if the unit is in a problem state.
Defaults
none
Command
Modes
EXEC Privilege
Command
History
Version 9.6.
(0.0)
Supported on the FN I/O Aggregator.
Usage
Information
This command is supported on the FN410S and the FN410T Aggregators
Resetting the management unit is not allowed and an error message displays if you
try to do so. Resetting is a soft reboot, including flushing the forwarding tables.
You can run this command directly on the stack standby unit (Standby Master) to
reset the standby. You cannot reset any other unit from the standby unit
419