Dell PowerEdge FX2/FX2s - Manual (Page 152)

0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 05:14:12
TenGigabitEthernet 0/2 is up, line protocol is down(error-
disabled[UFD])
Dell#
show interfaces description
Display the descriptions configured on the interface.
Syntax show interfaces [interface] description
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For the management interface on the stack unit enter the
keyword ManagementEthernet followed by the slot/
port information. The slot range is 0-0 and the port range
is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For VLAN interfaces, enter the keyword vlan followed by
a number from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information The following describes the show interfaces description command shown
in the Example below.
152