MTS Series 793 Application - Manual (Page 404)

MTS MultiPurpose TestWare®
Program Control Process
Other Process Descriptions 404
How to Define a Program Control Process
1. Drag the icon from the Process Palette to your procedure table.
2. Click the process icon in your procedure table or in the navigation pane.
3. Click the Action tab.
4. In the Action list, click the action for this process.
5. Optional—If you want to write a message to the log when this process
triggers, select the Log Message As check box and click Diagnostic,
Information, Warning, or Error in the list.
6. Type the message that you want to send to the various message logs when
the process triggers.Select Include Counters if desired.
7. Click the General tab.
8. In the Name box, type a name for this process. (You can also name the
process in the procedure table.)
9. Select the Process Enabled check box. (If this box is cleared, the process
will not run.)
10. In the Execute Process box, type number of times you want the process to
run.
11. Optional—In the Counter Type list, click a counter type.
12. Optional—If you enabled a counter, type a Counter Label.
13. Set the desired Start and Interrupt signals for the process in the procedure
table.