MTS Series 793 Application - Manual (Page 280)

MTS MultiPurpose TestWare®
Peak/Valley Acquisition Process
Data Acquisition Process Descriptions 280
Peak/Valley Acquisition Parameter Descriptions
Acquisition tab
General tab
Signals Tab Selects signals from which this process acquires data. Use the left and right
arrows to move desired signals from the Available list to the Included list.
Note The order of the signals in the Included list determines the order of the
columns of data in your data file. Use the up and down arrows to arrange
signals in the desired order.
Acquisition Tab
I TEM D ESCRIPTION
Master Signal Specifies the signal that is monitored by the peak/valley detector.
Sensitivity Defines how much the signal must change before a level is considered a peak
or valley.
Total Samples Specifies the number of samples the process will acquire before it completes.
Note If disabled, samples will be taken as long as the process is active.
General Tab
I TEM D ESCRIPTION
Name Specifies the process name displayed on the Procedure or Group process
window.
Process Enabled Enables the process. (Clear this box to disable the process.)
Execute Process Specifies the number of times the process will be run.
Counter Type Enables a process counter.
Options are None, Transient, or Fixed. Transient counters are displayed only
when the process is active. Fixed counters are displayed throughout the test.
Counter Label Names the counter.
When you run the test, this name appears under Sequence Counters on the
MPT control panel.
Note If this box is blank, the process name is used as the counter label.