IDEC High Performance Series - Manual (Page 98)

Chapter 2
80
External Device Setup Manual
In case of HG2F/3F/4F a connection cable is available. (part number: HG9Z-3C165).
There is no pin number corresponding to TERM on the HG2S. When inserting a termination resistor, use a communication
switch. For the setting of the switch, refer to Appendix "3 Important Points Regarding Wiring" on page 19.
D-sub, 25P connector socket type (unit side) D-sub, 25P connector socket type
D-sub, 25P connector socket type (unit side) D-sub, 37P connector plug type