IDEC High Performance Series - Manual (Page 288)

Chapter 2
270
External Device Setup Manual
We recommend that you switch on the termination resistor on the PLC Link Unit side for long-distance transmission con-
nection cable is available.
Screw terminal block D-sub, 25P connector socket type
Screw terminal block D-sub, 37P connector plug type
- We recommend that you switch on the termination resistor on the PLC Link Unit side for long-distance transmission con-
nection cable is available.
- There is no pin number corresponding to TERM on the HG2S. When inserting a termination resistor, use a communica-
tion switch. For the setting of the switch, refer to Chapter 1 "3 Important Points Regarding Wiring" on page 19.