IDEC High Performance Series - Manual (Page 152)

Chapter 2
134
External Device Setup Manual
When you use the Terminal Block type of HG1F, make sure to configure the Hardware Flow control to NONE.
D-sub, 9P connector socket type D-sub, 9P connector socket type
D-sub, 9P connector socket type Terminal
- We recommend that you switch on the termination resistor on the PLC Link Unit side for long-distance transmission.
- There is no pin number corresponding to TERM on the HG1F. When inserting a termination resistor, use a communica-
tion switch. For the setting of the switch, refer to Chapter 1 "3 Important Points Regarding Wiring" on page 19.