IDEC High Performance Series - Manual (Page 570)

Chapter 3
552
External Device Setup Manual
Project Settings -
Communication
Interface SERIAL 2/COM2 The use of Serial 2 depends on the fol-
lowing selected O/I type :
HG2G-5F, HG3G/4G series:
The use of Serial 2 depends on the fol-
lowing selected O/I type.
HG2G-5F, HG3G/4G series:
Serial 2 maybe selected as the “O/I
Link Master” for O/I Link communi-
cation, or select “Host Communica-
tion” as the communication interface
for PLC communication. Select “O/I Link Slave” for O/I Link
communication.
HG2G-S/-5S, HG1F/2F/3F/4F series: HG2G-S/-5S, HG1F/2F/3F/4F series:
Not Supported. Not Supported.
Touch: Touch:
Select the O/I Link Master as the
communication interface for th O/I
Link communication and the Exter-
nal Device Communication as
the communication interface for
External Device communication. Select the O/I Link Slave as the
communication interface for the O/I
Link Communication
O/I Link Using the O/I Link adaptor depends on
the selected O/I type:
HG2G-5F, HG3G/4G series:
Using the O/I Link adaptor depends on
the selected O/I type:
HG2G-5F, HG3G/4G series:
Not available. Not available.
HG2G-S/-5S, HG1F/2F/3F/4F series: HG2G-S/-5S, HG1F/2F/3F/4F series:
Select “O/I Link Master”. Select “O/I Link Slave” as the inter-
face used for O/I Link communica-
tion.
Touch: Touch:
Not Supported. Not Supported.
Baud Rate Match to the setting of O/I Link slave. Match to the setting of O/I Link master.
Project Settings -
System Start Time Set it according to the environment. Setting not required.
Use System Area When Use System Area is selected, we recommend that you make the setting so
that there is no overlap. Overlap between system areas can affect operation.
Use System Areas 3,
4
Watch Dog Set according to your application.
Device
Time
Dialog Box Name
- Tab Name Setting Master Slave 1 to 15