IDEC High Performance Series - Manual (Page 92)

Chapter 2
74
External Device Setup Manual
When using the QJ71C24 Serial Communication Unit, connect a terminator resistor in accordance with the instruction man-
ual.
Screw down terminal block D-sub, 25P connector socket type
Screw down terminal block D-sub, 37P connector plug type
- When using the QJ71C24 Serial Communication Unit, connect a terminator resistor in accordance with the instruction
manual.
- There is no pin number corresponding to TERM on the HG2S. When inserting a termination resistor, use a communica-
tion switch. For the setting of the switch, refer to Chapter 1 "3 Important Points Regarding Wiring" on page 19.