IDEC High Performance Series - Manual (Page 439)

421
16 YOKOGAWA
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
Con
nection
to a PLC
External Device Setup Manual
In MICRO/I and PLC, the name of A pole and B pole is reverse.
In MICRO/I and PLC, the name of A pole and B pole is reverse.
There is no pin number corresponding to TERM on the HG2S. When inserting a termination resistor, use a communication
switch. For the setting of the switch, refer to Chapter 1 "3 Important Points Regarding Wiring" on page 19.
Screw terminal block D-sub, 25P connector socket type
Screw terminal block D-sub, 37P connector plug type