External device setup manual – IDEC High Performance Series User Manual
Page 173
155
3 Omron
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
Con
nection
to a PLC
External Device Setup Manual
3.4.7
SYSMAC-CS1/CJ Series (Ethernet Communication Unit) Settings
Write the Communication Board setting items for the System Settings Area using a peripheral tool (such as Proconn).
The communication settings are fixed. Refer to the Ethernet Communication Unit manual for details.
IP Address (MICRO/I)
Set the IP address of MICRO/I.
(Set this item in Communication Interface tab.)
Subnet Mask
Set the subnet mask of MICRO/I.
(Set this item in Communication Interface tab.)
Default Gateway
Set the default gateway of MICRO/I.
(Set this item in Communication Interface tab.)
IP Address
(Etherent Communication Unit)
Set the IP address of Ethernet Communication Unit.
(Set this item in Host I/F Network tab.)
Port Number
(Etherent Communication Unit)
Set the port number of Ethernet Communication Unit.
(Set this item in Host I/F Network tab.)
FINS Network Address
(Ethernet Communication Unit)
Set the network address which is set in the Etherent Communication Unit.
(Set this item in Host I/F Network tab.)
FINS Node Address
(Ethernet Communication Unit)
Set the node address which is set in the Ethernet Communication Unit.
(Set this item in Host I/F Network tab.)
HMI FINS Network Address
Set the network address of the MICRO/I.
(Set this item in Host I/F Driver tab.)
HMI FINS Node Address
Set the node address of the MICRO/I.
(Set this item in Host I/F Driver tab.)