IDEC High Performance Series - Manual (Page 484)

Chapter 2
466
External Device Setup Manual
18.4 Environment Settings
Allowed communication settings for FLEX-PC, MICREX-F and MICREX-SX are as follows.
18.4.1 FLEX-PC (CPU)
18.4.2 FLEX-PC (Link)
Refer to the FLEX-PC user’s manual for the details of communication setting.
FUJI FLEX-PC (CPU) to MICRO/I settings
Items Details
Interface RS232C, RS485 4-wire
Baud Rate (bps) Use the same
settings as for the MICRO/I.
19200
Data Bits 8
Stop Bits 1
Parity Odd
Flow Control None
FUJI FLEX-PC (Link Module) to MICRO/I settings
Items Details
Interface RS232C RS485 4-wire
Operation Modes
*1
*1. Set up the mode switch of Interface Module as below.
RS232C: Mode switch is No.1.
RS485:Mode switch is No.3.
Command-setting-type start-stop synchronization non sequenced
format
Baud Rate (bps) Use the same
settings as for the MICRO/I.
1200, 2400, 4800, 9600 or 19200
Data Bits 7 or 8
Stop Bits 1 or 2
Parity None, Odd or Even
Flow Control None or Hardware
Station Number - 0-99(DEC)