Yaskawa MP920 Motion Module - Manual (Page 297)

6 SVB Module Specifications and Handling
6.2.5 Σ-II Series SERVOPACK Parameters
6-62
* /WARN signal types: Overload, Regenerative overload, Communications warning, Data setting
warning, and command warning
Note: 1. If more than one signal is assigned to one output circuit, the OR logic is applied.
2. The signals that are not detected because of the selected control mode are OFF. For exam-
ple, /COIN signal is OFF in speed control mode.
Pn511
(cont’d) 2nd /EXT1 Signal Mapping 0 to 3 Disabled. Inputs from
SI4.
4 Inputs from SI4 (CN1-44) input terminal.
5 Inputs from SI5 (CN1-45) input terminal.
6 Inputs from SI6 (CN1-46) input terminal.
7 Enabled.
8 Disabled.
D Inputs the reverse signal from SI4 (CN1-44).
E Inputs the reverse signal from SI5 (CN1-45).
F Inputs the reverse signal from SI6 (CN1-46).
9 to F Disabled.
3rd /EXT2 Signal Mapping 0 to F Same as /EXT1 Signal Mapping Inputs from
SI5.
4th /EXT3 Signal Mapping 0 to F Same as /EXT1 Signal Mapping Inputs from
SI5.
Pn512 1st Output Signal Reversal
for SO1 Output Terminal 0 Output signal is not reversed. Not reversed.
1 Output signal is reversed.
2nd Output Signal Reversal
for SO2 Output Terminal 0 Output signal is not reversed. Not reversed.
1 Output signal is reversed.
3rd Output Signal Reversal
for SO3 Output Terminal 0 Output signal is not reversed. Not reversed.
1 Output signal is reversed.
4th Reserved − − 0
(cont’d)
Parameter
No.
Digit Place Name Setting Description Factory
Setting